CAN-Bus shield with Croduino and relay module setup

TECHNICAL SUPPORT Communication Modules
1

Customer:

I’ve been reading and watching about this, and I think I understand what I need: three modules - a CAN-Bus shield to decode CAN signal IDs and function addresses, connected to an Arduino Uno to convert that data into logic states (On and Off) and send it to specific outputs. Then I need to add an Arduino relay module that activates individual relay outputs depending on the input to trigger certain actions. I saw you sent links to other manufacturers, but I’m interested to know where you fit in with Croduino.

Original message (Croatian)

Sada sam malo čitao, gledao, … znači ako sam dobro shvatio, meni treba 3 modula, Can-bus shield da bi dekodirao CAN dignale ID i adrese funkcija, to spojim sa Arduino Uno koji te podatke pretvori u logična stanja On i off te pošalje na određeni izlaz. Poslije još moram dodati Arduino relay modul da ovisno o ulazu aktivira pojedini izlaz na releju koji meni vrši neku radnju?

Obzirom da ste mi poslali link drugih proizvođača, zanims me gdje ste tu vi sa Croduino.

Originally submitted via Facebook on 26 March 2018. Migrated to the forum for community visibility.

2

Soldered Support:

CAN-Bus shield - yes, that’s correct. Arduino (Uno/Croduino Basic2) - yes, that’s correct. Relay - this depends on what you want to do with the signals you read. If you want to turn on/off some device (which is what the relay is for), then yes, you need a relay. You can use Croduino Basic2 instead of Arduino Uno.

Original message (Croatian)

Can-Bus shield -tako je

Arduino (Unp/Croduino Basic2) - tako je

Relej - to već ovisi što želite sa signalima koje očitate, ako želite paliti/gasiti neki uređaj(ono za što se relej koristi), onda da, onda trebate relej
Croduino Basic2 možete koristiti umjesto Arduino Uno.