Croduino Basic2 with multiple sensors and modules

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

I’m new to Croduino and would like to know: if I want to connect together a light sensor with LM393, a stepper driver LN2003 with motor, a 20x4 blue LCD, a DHT22 temperature and humidity sensor, a 2-channel relay module, and a Bluetooth module to a Croduino BASIC2 as one functional unit, how many BASIC2 boards do I need?

Original message (Croatian)

Bok bok. poštovanje, evo nikad nisam radio sa croduinom pa me zanima slijedeće: Ako želim spojiti zajedno senzor svijetlosti S LM393, stepper driver LN2003+motor, LCD 20x4 plavi, DHT22 senzot temp: i vlage, modul s relejom (2-kanalni) te Bluetooth modul sa croduino BASIC2 kao jednu funkcionalnu cjelinu, koliko mi BASIC2 pločica potrebno?

Hvala unaprijed!

Originally submitted via email support on 25 October 2017. Migrated to the forum for community visibility.

2

Soldered Support:

You can connect everything to a single Croduino Basic2 provided you also get an I2C LCD adapter for the LCD. The code will be somewhat more complex, but it’s possible to do.

If you’re a beginner and can afford to run the code on two boards, I recommend getting two units - it will be simpler for you to implement everything.

Original message (Croatian)

Sve ćete moći spojiti na jedan Croduino Basic2 uz uvjet da uzmete i I2C LCD adapter(za LCD): Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics

Bit će nešto složeniji kod, ali moguće je napraviti.

Ako ste početnik i možete si dopustiti da se kod vrti na dvije pločice, preporučam da uzmete dva komada - bit će Vam jednostavnije sve implementirati.