Croduino Hobby Set pushbutton with 4 legs won't fit breadboard

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

I purchased a Croduino Hobby set last week and started learning with it. I followed the instructions from lecture 2 on YouTube. It says to connect a pushbutton with 2 legs to the breadboard. However, all the pushbuttons in my set have 4 legs and they’re all bent. I can’t fit them into the holes on the breadboard. Where am I going wrong?

Original message (Croatian)

Prošli tjedan sam kupio Croduino Hobby set i počeo sam učit.

Pokušao sam spojit sve prema uputama iz 2. lekcije sa Youtube-a.

Tamo kaže da spojim Pushbutton koji ima 2 nožice na eksperimentalnu pločicu.

U mom setu svi pushbuttoni imaju 4 nožice i sve su ‘savinute’ i nikako ih ne mogu ‘ugurat’ u rupice na eksperimentalnoj pločici.

Molio bi vas pomoć!

Gdje grešim?!

Originally submitted via email support on 7 March 2016. Migrated to the forum for community visibility.

2

Soldered Support:

A pushbutton with 2 legs or 4 legs is actually the same thing - the 4-leg version just has two extra legs for easier connection. If you look at the included diagram, you’ll see that the dimensions are actually designed to connect between the channels of the breadboard.

Original message (Croatian)

drago nam je što se interesiraš za Croduino. Pushbutton s dvije ili 4 nožice je zapravo ista stvar, samo ovaj s četiri ima dvije nožice više za lakše spajanje.
Ako pogledaš sliku u prilogu vidjeti ćeš da su dimenzije zapravo prilagođene za spajanje između “kanalice” breadboarda.

Attachment omitted in migration: Untitled Sketch_bb.png