Dasduino CONNECT 5V pin replacement and power connection

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

I have a new Dasduino CONNECT with ESP8266. I don’t know how to connect it because there is no 5V pin anywhere. Which two pins can I use as a replacement for 5V and GND?

Original message (Croatian)

Pozdrav, imam novi croduino esp8266 Ne znam kako ga spojiti jer nigdje nema 5v pin. Zanima me koja dva pina mogu koristiti kao zamjenu za 5v i gnd.
Hvala!

Attachment omitted in migration: 20220320_210831.jpg

Originally submitted via email support on 20 March 2022. Migrated to the forum for community visibility.

2

Soldered Support:

On the Dasduino CONNECT the label is VCC, not V. You can supply power to VCC and GND, but note that the battery charger will not work this way because it only operates when power is supplied via USB.

Original message (Croatian)

Da na Dasduino CONNECT za oznaku nemamo V nego VCC. Dakle na VCC i GND možete dovesti napajanje, ali onda vam neće raditi punjač za bateriju jer on radi jedino kada se napajanje dovede na USB. Ako treba još nešto slobodno nas kontaktirajte.