Croduino Basic2 board, processor and port settings

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

How do I configure the board, processor, and port settings for this board?

Original message (Croatian)

zanima me kako idu postavke za navedenu pločicu što se tiče “board”,“processor”,“port”.

Originally submitted via email support on 9 March 2017. Migrated to the forum for community visibility.

2

Soldered Support:

Board: Arduino Nano

Processor: 328

Port: the one your OS assigns (Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics)

Original message (Croatian)

Board: Arduino Nano

Processor: 328

Port: koji Vam dodjeli OS (Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics)

3

Customer:

I have another problem. I copied the code for a membrane keypad into the Arduino IDE and got an error. I’ve included the details and output.

Original message (Croatian)

Imam još jedan problem. Dakle, prekopiram kod za membransku tipkovnicu u Arduinov program i izbaci mi error. U privitku možete sve detaljno vidjeti. Znate li o čemu se radi?

Attachment omitted in migration: Arduino.JPG

4

Soldered Support:

You don’t have the keypad.h library installed. Read this section: https://e-radionica.com/hr/blog/2015/08/19/kkm-matrix-membranska-tipkovnica-4x4/#Kod%20za%20modul

Original message (Croatian)

Nemate instaliran library, konkretno keypad.h.
Pročitajte ovaj kratki dio: https://e-radionica.com/hr/blog/2015/08/19/kkm-matrix-membranska-tipkovnica-4x4/#Kod%20za%20modul