Croduino STM32 setup with Arduino IDE

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

I purchased a Croduino STM32 and ST-Link Programmer for a university project. The product description refers to documentation, and I’ve reviewed the available materials and forum topics, but I can’t find instructions on how to set up the STM32 to work with Arduino IDE. Could you point me to a tutorial or guide?

Original message (Croatian)

STM32 HowTO

Kako trenutno ne mogu na forumu postaviti pitanje, postaviti cu ga ovdje.

Kupio sam kod Vas STM32 i STLink Programator za potrebe izrade projekta za fakultet. U opisu STM32 proizvoda piše da se za korištenje treba referirati na KKM. Prošao sam kroz KKM i teme na forumu no nisam našao kako osposobiti da STM32 radi sa ArduinoIDE. Molim Vas da me, ako nije problem, usmjerite na neki tutorial.

Originally submitted via email support on 17 March 2022. Migrated to the forum for community visibility.

2

Soldered Support:

You need to install STM32CubeProgrammer to obtain the necessary drivers for the ST-Link. After installing it, in Arduino IDE select the correct microcontroller and under Tools > Upload methods choose STM32CubeProgrammer(SWD). After that, you can upload code to the Croduino STM32 board via the ST-Link.

Original message (Croatian)

Potrebno je da si instalirate STM32CubeProgrammer kako bi s njime dobili potrebne drivere za ST-Link. Nakon što to instalirate potrebno je da u Arduino IDE odaberete točan mikrokontroler i da pod Tools>>Upload methods odaberete STM32CubeProgrammer(SWD).

Nakon toga možete preko ST-Linka uploadati kod na Croduino STM32 pločicu. Ako budete imali još pitanja slobodno se javite pa detaljnije objasnimo ako neki korak nije jasan.