Croduino upload error during program transfer

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

When I try to upload a program to my Croduino board, I get an error message.

Original message (Croatian)

Bok, kad pokusam prebaciti program na croduino plocicu izbacuje mi error kao na slici

Attachment omitted in migration: croduino.png

Originally submitted via email support on 25 September 2016. Migrated to the forum for community visibility.

2

Soldered Support:

Before first use, you need to complete some setup steps. If you haven’t already:

  1. Install the driver: Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics
  2. Configure Arduino IDE: https://e-radionica.com/hr/blog/2015/08/19/arduino-ide-i-prvi-kod/

Let us know how it goes.

Original message (Croatian)

trebali biste, prije prve upotrebe, napraviti neke postavke. Ukoliko već niste neke od ovih:

Instalacija drivera: Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics
Arduino IDE postavke: https://e-radionica.com/hr/blog/2015/08/19/arduino-ide-i-prvi-kod/

Javite kako je prošlo.
Ugodan dan.