Damba module programming on Croduino with pin mapping

TECHNICAL SUPPORT NULA Development Boards
1

Customer:

I recently purchased some Damba modules and am trying to find documentation on how to program them using Croduino. I’ve looked at various schematics online and tried to map the pins, but haven’t had success. For example, I found How to Program Attiny Using Arduino Uno : 4 Steps - Instructables but it doesn’t include a 1:1 pin mapping for Croduino. Can you provide a basic schematic showing which pins connect where on the Croduino and where the capacitor goes?

Original message (Croatian)

prije par dana sam kupio par Damba modula preko Vašeg online shopa. Pokušao sam pronaći na netu shemu kako se programiraju preko croduin-a ali bezuspješno. Gledao sam neke druge sheme i pokušao mapirati pin-ove, također bez uspješnog rezultata. npr: How to Program Attiny Using Arduino Uno : 4 Steps - Instructables

Molim Vas, možete li poslati barem neku osnovnu shemu koje nožice se gdje spajaju na croduino i gdje ide kondenzator. Shema po kojoj sam ja pokušavao to napraviti ne uključuje mapiranje nožica 1:1 sa croduinom pa iz tog razloga i šaljem ovaj upit, čisto da otklonim sumnje.

Originally submitted via email support on 26 November 2015. Migrated to the forum for community visibility.

2

Soldered Support:

The easiest approach is to connect the Damba to the Basic board by connecting the pin on the Damba marked 13 to pin 13 on the Basic. In that case, set pin 9 to LOW and pin 8 to HIGH. Connect the capacitor’s negative lead to GND and the positive lead to the RST pin on the Basic.

The Instructables tutorial isn’t ideal for this. Instead, try High-Low Tech[address removed]. The Damba pinout can be found at Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics.

Original message (Croatian)

isprike na nepružanju dokumentacije. Pripremamo tutorial, ali biti će spreman tek početkom idućeg tjedna.
Najlakše je spojiti Dambu na Basic tako da pin(na Dambi) na kojem piše 13 spojite na pin13 Basica. U tom slučaju pin9 postavite na LOW, te pin 8 HIGH. Kondenzator (-) nožicu spojite na gnd, (+) nožicu na rst pin Basica.
Tutorijal s instructables nije baš najbolji, probajte s ovim: High-Low Tech[address removed] ovom linku se nalazi Pinout za Dambu: Soldered: Open-Source Electronics, Boards, Sensors & Modules – Soldered Electronics
Svakako se javimo kada tutorial bude gotov.