L86 M33 EasyC: LOCUS data logging and raw command access

TECHNICAL SUPPORT Communication Modules
1

Customer:

How do I start LOCUS data logging and download it from the GPS flash? I don’t see an option for this in the library, so the only thing I can think of is sending raw commands. Also, is it possible to upload schematics? Currently there’s only one for the non-EasyC version.

Original message (Croatian)

Kako mogu početi LOCUS data logging i isti skinuti sa GPSovog flasha? U librariju koliko ja vidim nema opcije – te jedino što mi pada na pamet je poslati raw command. Usput – postoji li mogućnost uploadadnja schematics? Trenutno postoji samo za non-EasyC verziju.

Hvala vam unaprijed!

Originally submitted via email support on 18 September 2024. Migrated to the forum for community visibility.

2

Soldered Support:

The schematics should be available here: GitHub - SolderedElectronics/GNSS-GPS-L86-M33-breakout-hardware-design: Hardware design, BOM, gerbers and 3D files for GNSS-GPS-L86-M33-breakout designed by Soldered Electronics. · GitHub

Our library doesn’t have LOCUS support, but it does support sending your own commands: Soldered-GNSS-L86-M33-Arduino-Library/src/GNSS-L86-M33-SOLDERED.cpp at f9fb51017f643742f9c3b3bd815b10e00d5944ce · SolderedElectronics/Soldered-GNSS-L86-M33-Arduino-Library · GitHub

Original message (Croatian)

ovdje bi trebala biti shema za to: GitHub - SolderedElectronics/GNSS-GPS-L86-M33-breakout-hardware-design: Hardware design, BOM, gerbers and 3D files for GNSS-GPS-L86-M33-breakout designed by Soldered Electronics. · GitHub

Za LOCUS naš library nema support ali ima support slanje vlastitih komandi: Soldered-GNSS-L86-M33-Arduino-Library/src/GNSS-L86-M33-SOLDERED.cpp at f9fb51017f643742f9c3b3bd815b10e00d5944ce · SolderedElectronics/Soldered-GNSS-L86-M33-Arduino-Library · GitHub

Sretno s projektom i javi ako imaš još dodatnih pitanja :slight_smile:

3

Customer:

To get the raw output from the GPS itself, which I need to read LOCUS - do I just hook into the same SoftwareSerial that the GPS uses?

Original message (Croatian)

Pozdrav! Hvala vam na brzom odgovoru - čisto da pitam pa da budem 100% siguran.
Za to da dobijem output od samog GPS-a, tj. raw output koji mi treba da mogu čitati LOCUS- samo se hookam na isti SoftwareSerial koji se koristi od GPS-a?
Hvala vam unaprijed.

4

Soldered Support:

Yes, you can access that software serial object through gps.gnssSerial->read() (for example).

Original message (Croatian)

Pozrav Teo,

da, možeš pristupiti tom software serial objektu putem gps.gnssSerial->read() (npr).